DieHard 200.71225 Instrukcja obsługi - Strona 12

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Ładowarka DieHard 200.71225. DieHard 200.71225 20 stron. Microprocessor controlled, fully automatic operation battery charger with engine starter plus battery and alternator tester for 6 and 12-volt batteries
Również dla DieHard 200.71225: Instrukcja obsługi (17 strony)

Drukuj stronę

aborted charge, either disconnect the battery or unplug the charger.

12.4

dESULFATION MOdE:

period of time, it could become sulfated and not accept a normal charge. If

the charger detects a sulfated battery, the charger will switch to a special

mode of operation designed for such batteries. Activation of the special

desulfation mode is indicated by the CHARGING (yellow) LED blinking.

If successful, normal charging will resume after the battery is desulfated.

The CHARGING (yellow) LED will then stop blinking and light continu-

ously. Desulfation could take up to 10 hours. If desulfation fails, charging

will abort and the CHECK (red) LED will blink.

12.5

COMPLETION OF CHARgE:

CHARGED (green) LED. When lit, the charger has stopped charging and

switched to the Maintain Mode of operation. If the 12V DEEP CYCLE

battery type was selected for other charge types, the CHARGED (green)

LED comes on when the battery is charged enough for normal use.

12.6

MAINTAIN MOdE

has started Maintain Mode. This mode of operation is also known as

Float-Mode Monitoring. In this mode, the charger keeps the battery fully

charged by delivering a small current, when necessary. The voltage

is maintained at a level determined by the BATTERY TYPE selected.

NOTE: For charge types other than DEEP CYCLE, the CHARGED LED

might be lit before Maintain Mode is started.

12.7

gENERAL CHARgINg NOTES:

cooling fan for efficient operation. Consequently, it is normal for the fan to

start and stop when maintaining a fully charged battery. The fan does not

run in Tester Mode.

If the charge mode is changed after charging has started (by pressing the

CHARGE RATE or BATTERY TYPE button), the charging process will

restart.

The voltage displayed during charging is the charging voltage and is usually

higher than the battery's resting voltage.

If a battery is left discharged for an extended

Charge completion is indicated by the

: When the CHARGED (green) LED is lit, the charger

The charger is designed to control its

•