Olympus BH2-CH Substage Montaż - Strona 16

Przeglądaj online lub pobierz pdf Montaż dla Mikroskop Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 stron.

Reinstall the Locking and Centering Thumbscrews

Lightly grease the threads of the condenser-locking

thumbscrew (see

Figure

thumbscrew into the centering yoke (see

Figure 52 – Lightly grease the locking thumbscrew

Figure 53 – Reinstall the locking thumbscrew

Lightly grease the threads of the two condenser-

centering thumbscrews (see

thumbscrews into the support yoke (see

Figure 54 – Lightly grease the centering thumbscrews

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

52) and reinstall the

Figure

53).

Figure

54) and reinstall the

Figure

55).

Figure 55 – Reinstall the centering thumbscrews

Note: Disassembly of the friction lock is not necessary, but is shown here for

the sake of completeness.

Use a 3.0mm Allen wrench or driver to remove the

M4x12 hex socket-head cap screw for the plastic

friction lock (see

Figure

Figure 56 – Loosen and remove the friction-lock screw

Remove the plastic friction lock from the bore in the

left-hand side of the main housing (see

Figure 57 – Remove the plastic friction lock from housing

Insert the plastic friction lock into the bore in the left-

hand side of the main housing, with the recessed hole

facing outwards (see

Figure

56).

Figure

57).

58).

Revision 1

Page 16 of 26