Olympus BH2-CH Substage Montaż - Strona 18

Przeglądaj online lub pobierz pdf Montaż dla Mikroskop Olympus BH2-CH Substage. Olympus BH2-CH Substage 26 stron.

Drukuj stronę

pulling it straight out, away from the main housing (see

Figure 64

and

Figure

62). Reinsert the alignment pins

back into the dovetail block if necessary.

Figure 64 – Remove left dovetail block from the housing

Use a cotton swab and a suitable solvent (e.g., acetone)

to clean the grease from the two dovetail blocks (see

Figure

65).

Figure 65 – Clean grease from the dovetail blocks

Remove the Condenser-Height Knob

Use a 1.5mm Allen wrench or driver to loosen the two

M3x4 set screws securing the condenser-height knob to

the condenser-height shaft (see

Figure 66 – Loosen set screws in condenser-height knob

Remove

the

condenser-height

condenser-height shaft (see

Complete Teardown, Cleaning/Lubrication, and Reassembly of the Olympus BH2-CH Substage Assembly

Figure

66).

knob

from

Figure

67).

Figure 67 – Remove the condenser-height knob

Remove the Condenser-Height Shaft

Use a suitable tool (e.g., sharp needle-nose pliers) to

loosen the lock nut for the tension screw for the

condenser-height shaft (see

Figure 68 – Loosen the tension-screw lock nut

Unscrew and remove the lock nut from the tension

screw (see

Figure

Figure 69 – Unscrew and remove tension-screw lock nut

Use a suitable slotted screwdriver to loosen the

the

condenser-height tension screw (see

Figure

68).

69).

Figure

Revision 1

70).

Page 18 of 26