Olympus CX23 Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Mikroskop Olympus CX23. Olympus CX23 32 stron. Biological microscope

Olympus CX23 Instrukcja obsługi

CAUTION - Electrical safety -

Always use the AC adapter and power cord provided by Olympus.
If the proper AC adapter and power cord are not used, the electric safety and EMC (Electro-Magnetic Compatibility )
performance of the device can not be assured. If no power cord is provided, please select the proper power cord by
referring to the section "Proper selection of the power supply cord" at the end of this instruction manual.
Ground the device.
Connect the ground terminal of the power cord and that of the power outlet. If the device is not grounded, our intended
electric safety and EMC performance of the device can not be assured.
Do not use the device in close proximity to the sources of strong electromagnetic radiation.
Proper operation may be interfered. The electromagnetic environment should be evaluated prior to operation of the
device.
Remove the power cord in case of emergency.
Install the product at a location where you can reach the power cord connector or the power outlet at hand to remove
the power cord quickly.
This device complies with the emission and immunity requirements described in IEC61326 series.

CAUTION - LED (light emitting diode) -

Do not directly look at the light from the LED unit for a long time.
If you feel that the light from LED units is too bright during observation, adjust the intensity using the brightness
adjustment knob and continue observation. The LED built in this product is basically eye-safe. However, direct viewing
the light from the LED unit for extended time in the state you feel dazzling may cause damage to the eyes.

CAUTION -Safety symbols-

The following symbols are found on the microscope. Study the meaning of the symbols and always use the equipment
in the safest possible manner.
Symbol
2
Indicates a non-specific general hazard. Follow the description given after this
symbol or in the instruction manual.
Indicates that the main switch is ON.
Indicates that the main switch is OFF.
Explanation