Olympus PT-E03 Instrukcja obsługi - Strona 20

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Akcesoria do kamer Olympus PT-E03. Olympus PT-E03 41 stron. Underwater case for digital camera e-410/e-400

Drukuj stronę

How to attach the camera table to the digital camera

In order to load the camera into the Case, attach the camera table (located on the front-lid side of the

Case) to the digital camera.

1 Attach the camera table to the tripod seat section on

the bottom of the digital camera. Use the camera's

tripod screw hole for attaching.

2 The camera table has fixed up-down and front-rear

orientations. To ensure that it is properly attached,

refer to the illustration on the right.

Using the electronic flash

To attach the combination of the FL-20 Electronic Flash and the PFL-01 underwater flash case or the

FL-36 Electronic Flash and the PFL-E01 underwater flash case to this Case, connect the hot shoe cable

provided with the PFL-01 or PFL-E01 to the camera and to the hot shoe cable connector on the front lid

side of this Case as described below. Note that the camera's built-in flash cannot be used when an

external electronic flash and case are installed. Be sure to set the automatic pop-up setting of the camera

to OFF so that the builtin flash will not pop up automatically.

1 Before loading the camera in the Case, connect the

hot shoe cable's connector to the Case's hot shoe

cable connector.

EN 19

Front

Down

Rear