Axkid Minikid Podręcznik użytkownika - Strona 5

Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Fotelik samochodowy Axkid Minikid. Axkid Minikid 8 stron.

Skip this part

if your car is

equipped with

attachment loops

the child should fall asleep. Rule of thumb

is that the older the child gets, the more

upright you can put the seat. Also note that

the chair will be angled down slightly when

it is clamped in the seat belt and sinking into

the car's seat.

Attach the car's seat belt

Open both belt clips (3) of the chair.

Grasp the seat belt and pull it out a bit to

allow for mounting as shown below. The hip

section of the belt must be at least 70 to 80

cm long.

Place then the belt through the hole in the

belt clip (4) and push it underneath the fabric

until it comes out on the other side. If you

prefer you can pull the belt across the fabric.

Fasten the belt. Tighten securely, the belt

that goes through or over the seat should be

tight everywhere. Attach the belt in the belt

buckle. Both the hip and shoulder belt should

be fastened in the clip closest to the car's seat

belt buckle. Only the hip belt should be

fastened in the clip farthest to the car's seat

belt buckle.

Your vehicle may have two loops at the

front seat rails, or in case the seat is mounted

in the front seat, in front of the seat.

When there are no loops in your car the

supplied fixing band that is lying in the chair

should be used instead. If you installed the

seat in the back seat pass the one end through

either the rear of the front seat rails or other

suitable attachment point on the front seat.

The loop should be as close to the floor as

possible. Use therefore a strap with a suitable

length, and pass the loop through one of the

band openings.

Continued on next page