Olympus CX-DO Instrukcja obsługi - Strona 2
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Sprzęt laboratoryjny Olympus CX-DO. Olympus CX-DO 13 stron. Dual-viewing attachment
Drukuj stronęCX-DO
This unit employs a UIS (universal infinity system) optical design, and should only be
used with the CX40 microscope frame and UIS eyepieces, objectives, condensers,
etc. Less than optimum performance may result if inappropriate accessories are used.
I, This manual pertains only to the CX-DO. Before using this attachment with the microscope, also thoroughly
review
the instruction manual for the CX40 microscope
frame.
2. To avoid potential shock hazard, always turn the main switch on the transformer
(TDO) to OFF and disconnect the
power cord before replacing the pointer illumination
bulb.
3. Never connect the pointer illumination cord plug to other units than the TDO transformer.
4. When replacing the pointer illumination
bulb, be sure to use only the designated tungsten bulb.
I
Designated bulb: 6V IOWGE (mfd. by Hosobuchi Denkyuu).
I
2. Orientation of the
image
is
the same for both observers.
3. Observation tubes and eyepieces that can be used with the CX-DO are as follows.
Eyepiece
CWHlOX
Eyepiece
helicoid
CWHlOX,
, ~.
CWHlOX
with
observation
tube
U-B130
Eyepiece with
helicoid
CWHlOX-H or
1351 WHlOX
Cross-WHlOX.
Transformer
TDO
Main observer
Secondary
observer
Dual-viewing
body
cx-Do
Binocular
observation
tube
U-B130
Eyepiece
with helicoid
CWHIOX-H
1. ml
Eyepiece
CWHlOX
etc.
Trinocular
observation
tube
U-TR30