Arc Euro Trade SC3 Instrukcja demontażu i ponownego montażu - Strona 10
Przeglądaj online lub pobierz pdf Instrukcja demontażu i ponownego montażu dla Tokarka Arc Euro Trade SC3. Arc Euro Trade SC3 17 stron.
Drukuj stronę83. Scrape any paint off the bed shears.
91. Loosen shear plate adjusting screws below the level of the plate and loosely fit to saddle.
Carry out all the following adjustments to both the
front and rear shear plates step by step.
93. Lightly pinch middle cap screw.
84. Trial fit the rack to check if it seats well or rocks.
86. Drill and tap the fixing holes deeper if necessary.
94. Screw in adjusting screws until just touching.
95. Slacken the middle cap screw.
96. Screw in both adjusting screws 1/2 turn.
97. Pinch up middle cap screw.
87. Final fit rack making sure it seats properly in the corner.
92. Oil bed and saddle and slide saddle onto bed.
98. Test slide saddle up and down the bed. There
- 10 -
85. If necessary, radius top rear edge of
the rack and trial fit again.
88. Place the saddle on the bed and
check to see how it sits.
89. If it rocks, blue the bed and slide
the saddle up and down to find the high
spots.
90. Scrape, file or stone down the high
spots until the saddle sits flat on the bed.
should be slight drag with no free play. Lightly
pinch up remaining cap screws checking after
each one and adjusting as required.