Arc Euro Trade SC3 Instrukcja demontażu i ponownego montażu - Strona 11
Przeglądaj online lub pobierz pdf Instrukcja demontażu i ponownego montażu dla Tokarka Arc Euro Trade SC3. Arc Euro Trade SC3 17 stron.
101. The leadscrew brackets as they come on
the machine. Notice there is no means of
lubricating the bearing surfaces other than at
each end of the bracket.
104. Loosely fit leadscrew bracket & grease bore.
106. Grease end of leadscrew and bracket bore and temporarily fix in place.
99. Oil and/or grease the gears and shafts, dovetail and half nut of the
apron assembly. Check 1/2 nut dovetail is correctly adjusted by
operating the lever.
100. Temporarily fit the apron to the saddle.
102. Drill oil holes through to the bore using a
centre drill.
105. Grease end of leadscrew and feed through 1/2 nut and into bracket at headstock end.
- 11 -
103. Finish off by cutting oil grooves in the bore
using a Dremel and a 3mm ball end burr
similar to the one shown in the inset.
(ARC code: 060-030-00310 - Carbide Burr 3mm Ball)