Arc Euro Trade SC3 분해 및 재조립 매뉴얼 - 페이지 11

{카테고리_이름} Arc Euro Trade SC3에 대한 분해 및 재조립 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Arc Euro Trade SC3 17 페이지.

101. The leadscrew brackets as they come on

the machine. Notice there is no means of

lubricating the bearing surfaces other than at

each end of the bracket.

104. Loosely fit leadscrew bracket & grease bore.

106. Grease end of leadscrew and bracket bore and temporarily fix in place.

99. Oil and/or grease the gears and shafts, dovetail and half nut of the

apron assembly. Check 1/2 nut dovetail is correctly adjusted by

operating the lever.

100. Temporarily fit the apron to the saddle.

102. Drill oil holes through to the bore using a

centre drill.

105. Grease end of leadscrew and feed through 1/2 nut and into bracket at headstock end.

- 11 -

103. Finish off by cutting oil grooves in the bore

using a Dremel and a 3mm ball end burr

similar to the one shown in the inset.

(ARC code: 060-030-00310 - Carbide Burr 3mm Ball)