Arc Euro Trade SC3 Manual de desmontagem e remontagem - Página 11

Procurar online ou descarregar pdf Manual de desmontagem e remontagem para Torno Arc Euro Trade SC3. Arc Euro Trade SC3 17 páginas.

101. The leadscrew brackets as they come on

the machine. Notice there is no means of

lubricating the bearing surfaces other than at

each end of the bracket.

104. Loosely fit leadscrew bracket & grease bore.

106. Grease end of leadscrew and bracket bore and temporarily fix in place.

99. Oil and/or grease the gears and shafts, dovetail and half nut of the

apron assembly. Check 1/2 nut dovetail is correctly adjusted by

operating the lever.

100. Temporarily fit the apron to the saddle.

102. Drill oil holes through to the bore using a

centre drill.

105. Grease end of leadscrew and feed through 1/2 nut and into bracket at headstock end.

- 11 -

103. Finish off by cutting oil grooves in the bore

using a Dremel and a 3mm ball end burr

similar to the one shown in the inset.

(ARC code: 060-030-00310 - Carbide Burr 3mm Ball)