Arc Euro Trade SC3 Manual de desmontagem e remontagem - Página 9

Procurar online ou descarregar pdf Manual de desmontagem e remontagem para Torno Arc Euro Trade SC3. Arc Euro Trade SC3 17 páginas.

76. Remove the tumbler reverse

assembly and belt cover again.

79. When adjusting belt tension, it should

twist easily through 90°

Running the spindle for the first time:

1. Follow the Start-Up procedure with the motor running forwards.

2. Run the machine at a low RPM. The machine should run smoothly with minimal noise and

vibration. If not turn off the machine and investigate the cause of the problem.

3. Increase the speed and run for 10 minutes at a higher RPM.

81. After running the spindle to warm it up and settle the grease, check and adjust

the preload again. Lock the C nuts when the preload appears to be OK. Take

care not to overdo the preload as this could overheat and damage the bearings.

77. Fit the drive belt and adjust the belt tension.

80. Run the spindle following the procedure below and check the belt is centred on the pulley. If not

the motor angle may be adjusted by slackening these screws. Check the belt tension again.

- 9 -

78. Belt tension adjustment screws.

82. Re-fit the belt cover.