Axxess AX-DSPX-HD1-WR Instrukcja instalacji - Strona 3

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Akcesoria samochodowe Axxess AX-DSPX-HD1-WR. Axxess AX-DSPX-HD1-WR 8 stron.

1. Remove the fairing to access the back of the factory radio. Refer to MetraOnline,

part number 99-9600 for fairing disassembly instructions.

2. Install the AX-DSPX-HD1-WR harness and make all necessary connections, but leave the

amp turn-on wire disconnected.

3. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from

the AX-DSPX-HD1-WR harness into the left side of the cap. The locking clip on the

connector should face upward. Make sure the gasket is seating properly in the cap.

(Figure A)

4. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector

from the AX-DSPX-HD1-WR harness into the right side of the cap. The locking clip on

the connector should face upward. Make sure the gasket is seating properly in the cap.

(Figure A)

5. Plug the 16-pin and 20-pin connectors from the AX-DSPX-HD1-WR harness into the

AX-DSPX-X circuit board. (Figure A)

6. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure

location in the fairing to secure it. Make sure the Axxess logo is facing up to further

ensure that no outside elements can enter the enclosure.

INSTALLATION

Continued on the next page

(Figure A)

Case

AX-DSPX-HD1-WR

Circuit Board

Cap (with O-ring)

16-Pin

Gasket

AX-DSPX-HD1-WR

Harness

Zip-tie Mounts

20-Pin

REV. 8/16/2019 INSTAX-DSPX-HD1-WR