Axxess AX-DSPX-HD1-WR Інструкція з монтажу Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Автомобільні аксесуари Axxess AX-DSPX-HD1-WR. Axxess AX-DSPX-HD1-WR 8 сторінок.

Axxess AX-DSPX-HD1-WR Інструкція з монтажу Посібник з монтажу
1. Remove the fairing to access the back of the factory radio. Refer to MetraOnline,
part number 99-9600 for fairing disassembly instructions.
2. Install the AX-DSPX-HD1-WR harness and make all necessary connections, but leave the
amp turn-on wire disconnected.
3. With the arrow stamped onto the cap facing upwards, push the 16-pin connector from
the AX-DSPX-HD1-WR harness into the left side of the cap. The locking clip on the
connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
4. With the arrow stamped onto the cap still facing upwards, push the 20-pin connector
from the AX-DSPX-HD1-WR harness into the right side of the cap. The locking clip on
the connector should face upward. Make sure the gasket is seating properly in the cap.
(Figure A)
5. Plug the 16-pin and 20-pin connectors from the AX-DSPX-HD1-WR harness into the
AX-DSPX-X circuit board. (Figure A)
6. Slide the assembly into the case, then click it shut. Zip-tie the enclosure to a secure
location in the fairing to secure it. Make sure the Axxess logo is facing up to further
ensure that no outside elements can enter the enclosure.
INSTALLATION
Continued on the next page
(Figure A)
Case
AX-DSPX-HD1-WR
Circuit Board
Cap (with O-ring)
16-Pin
Gasket
AX-DSPX-HD1-WR
Harness
Zip-tie Mounts
20-Pin
REV. 8/16/2019 INSTAX-DSPX-HD1-WR
3