Epson 11880 - Stylus Pro Color Inkjet Printer Instrukcja rozpakowywania i konfiguracji - Strona 18

Przeglądaj online lub pobierz pdf Instrukcja rozpakowywania i konfiguracji dla Drukarka Epson 11880 - Stylus Pro Color Inkjet Printer. Epson 11880 - Stylus Pro Color Inkjet Printer 28 stron. Stylus pro11880
Również dla Epson 11880 - Stylus Pro Color Inkjet Printer: Skrócona instrukcja obsługi (14 strony), Broszura (1 strony), Broszura i specyfikacje (8 strony), Instrukcja obsługi dla sieci (46 strony), Podręcznik z informacjami o produkcie (10 strony), Ograniczona gwarancja (12 strony), Broszura i specyfikacje (7 strony), Broszura i specyfikacje (8 strony)

Drukuj stronę

Epson 11880 - Stylus Pro Color Inkjet Printer Instrukcja rozpakowywania i konfiguracji

Printing a status sheet

1. Press the Paper Source

Roll Auto Cut On

2. Press the Menu

button to enter Menu

mode.

3. Press the Paper Feed

TEST PRINT, and then press the Menu

button.

4. Press the Paper Feed

STATUS SHEET, and then press the Menu

button.

5. Press the Enter

button to print a status

sheet.

After printing is finished, follow the message

on the LCD panel to return to the READY state.

button to display

Loading the Cut Sheet Media

To load cut sheet media longer than Super A3/B

(483 mm), see the next section. To load cut sheet

media with a length of Super A3/B (483 mm) or

below, see "Loading cut sheet media with a length

of Super A3/B (483 mm) or below" on page 18.

If you are printing on thick paper (0.5 to 1.5 mm),

see "Printing on thick paper (0.5 to 1.5 mm)" on

page 19.

Note:

When you use paper other than Epson special media,

see the instructions included with the paper, or contact

your supplier for more information.

Loading cut sheet media longer than

Super A3/B (483 mm)

1. Make sure that the printer is on and the roll

paper cover is closed.

2. Press the Paper Source

until Sheet

appears.

3. Make sure that the Paper Check light is on,

and then set the paper lever to the released

position. LEVER RELEASED. LOAD PAPER

appears on the LCD panel.

The paper lever may be locked if REMAINING

PPR SETUP is set to ON: AT ROLL EXCHANGE. In

this case, press and hold the Enter

for 3 seconds to print the barcode, so you can

release the paper lever.

button repeatedly

button