Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO Instrukcja konfiguracji

Przeglądaj online lub pobierz pdf Instrukcja konfiguracji dla Drukarka Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO. Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO 2 stron. 24-pin dot matrix printer
Również dla Epson 24-PIN DOT MATRIX PRINTER LQ-680PRO: Podręcznik użytkownika (22 strony), Skrócona instrukcja obsługi (12 strony), Podręcznik użytkownika (17 strony), Specyfikacje (2 strony), Specyfikacje (3 strony), Podręcznik referencyjny (34 strony)

Drukuj stronę

24-pin Dot Matrix Printer

Setup

Unpacking the Printer

printer

Software CD-ROM

power cord

Assembling the Printer

1. Make sure the printer is turned off and unplugged.

2. Attach the paper guide.

3. Open the printer cover.

4. The print head should be in the replacement position indicated by an indentation

in the front metal plate, as shown below.

Connecting the Printer to Your Computer

Connecting the printer

Make sure both the printer and computer are turned off, then connect the interface

into the printer and computer.

4041764-00

xxx

paper guide

ribbon cartridge

Setup Guide

Notice sheet

Cautions and Notes

Cautions

must be observed to avoid damage

to your equipment.

Remove the protective materials

Follow the directions on the Notice Sheet to remove the protective materials.

Save all packing and protective materials in case you need to ship the printer in the

future.

5. Turn the ribbon-tightening knob on the ribbon cartridge in the direction of the arrow

to take up any slack in the ribbon.

6. Hold the ribbon cartridge with the exposed ribbon down and the ribbon-tightening

knob facing you, and guide the ribbon under the print head. Then snap the

cartridge into place so that the tabs on both sides of the cartridge fit into the

notches in the cartridge holder.

7. Hold the ribbon cartridge by its handle and push it firmly down into position; then

press on both ends of the cartridge to make sure the plastic hooks fit into the slots.

8. Turn the ribbon-tightening knob again to remove any slack in the ribbon and to

make sure the ribbon moves freely.

9. Close the printer cover.

Plugging in the printer

1. Make sure the printer is turned off.

2. If the power code is not attached to the printer, plug the appropriate end into the

AC inlet on the back of the printer.

3. Plug the power code into a properly grounded electrical outlet.

Notes

contain important information and useful tips on

the operation of your printer.