Creek Audio 4040 A Instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Wzmacniacz Creek Audio 4040 A. Creek Audio 4040 A 13 stron.

ADVANCED MENU

POWERING THE AMPLIFIER

The mains POWER ON/OFF switch marked 0 and l is located on the rear panel. To power the amplifier ON, depress

the mains switch to position l. The CREEK logo will illuminate on the display screen followed two seconds later by

the home screen showing the amplifier's status.

ECO MODE

To comply with International Ecological Power Regulations, electrical consumer products are required to lower their

power consumption to <0.5W when idle for 30 mins or more. Therefore, the 4040 A automatically enters STANDBY

mode if it doesn't detect user interaction or an audio signal for a pre-set time.

AUTO STANDBY

Enter the MENU to adjust the STANDBY timeout. Options 30 mins, 60 mins, 120 mins, or Always On. A graphical

timer symbol will be displayed when Auto Standby is enabled.

POWER CORDS

The 4040 A is supplied with a good quality power cord with mains plug matching the power socket used in your

region or country. If in doubt, consult your dealer, or the official importer. After-market power cords are unlikely to

improve audio performance due to the high-tech "regenerative" high frequency power supply used by the 4040 A.

MAINS VOLTAGE SELECTOR

To prevent accidental use, the two-way mains voltage switch is protected by a transparent cover. If the amplifier is

to be used in a different voltage region to its factory setting, the switch must be moved. Loosen both screws by half

a turn and swing the transparent cover out of the way to access the switch, move the switch left or right to reveal

either 115V or 230V. Replace the plastic cover and tighten the two screws before connecting to the mains.

The technically advanced 4040 A is very energy efficient. It draws only 5 Watts power from the mains continuously

when powered-ON with no signal, but less than 0.5W in STANDBY mode. In STANDBY mode, a subsidiary power

supply produces a low voltage to continuously power the amp's system microcontroller. The microcontroller draws

very little power but must be powered to wait for instructions to turn the main power supply on and start the

amplifier working.

Creek Audio recommends switching the amplifier OFF completely if not used for a prolonged time, like holidays,

vacations, etc. The internal mains safety fuse is not user serviceable.

There are no user serviceable parts inside the amplifier.

Page: