Digisol DG-CS4616F Instrukcja instalacji - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Przełącznik Digisol DG-CS4616F. Digisol DG-CS4616F 17 stron. Giga layer 3 switch

examined.

Caution!

Please verify the sign above the port to ensure using the right port. Connecting to wrong

ports might damage the switch.

Fiber cables should be connected as below:

Step 1: remove the protective plug from the SFP/SFP+ fiber transceiver bore; Remove the

protective cap from one end of the fiber cable. Keep the fiber end clean and neat.

Step 2: Attach one end of the fiber cable to the SFP/SFP+ transceiver, and attach the

other end to the transceiver of the other devices. Note: SFP/SFP+ transceiver's TX port

should be connected to RX port of other device, and SFP/SFP+ transceiver's RX port

should be connected to TX port of other device.

Step 3: Check the fiber port status indicator, a light LED indicates that the link has been

established; otherwise the link is not ready and should be examined.

Caution!

Please verify the sign above the port to ensure using the other ports. Connecting to wrong

ports might damage the transceiver or the other ports. When connecting other devices

through a fiber cable to the switch, the output power of the fiber cable must not exceed the

maximum received power of the corresponding modules. Otherwise, it will damage the

fiber transceiver. Do not stare at the fiber bore when the switch is in operation. That may

hurt your eyes.

2.3.5 Power Supply Connection

DG-CS4616F uses 220V AC power. Please read the power input specification for the

detailed information.

Power supply connection procedure is described as below:

DG-CS4616F Installation Guide

Chapter 2-9