Digisol DG-CS4616F Installation Manual - Page 15
Browse online or download pdf Installation Manual for Switch Digisol DG-CS4616F. Digisol DG-CS4616F 17 pages. Giga layer 3 switch
Print Page
examined.
Caution!
Please verify the sign above the port to ensure using the right port. Connecting to wrong
ports might damage the switch.
Fiber cables should be connected as below:
Step 1: remove the protective plug from the SFP/SFP+ fiber transceiver bore; Remove the
protective cap from one end of the fiber cable. Keep the fiber end clean and neat.
Step 2: Attach one end of the fiber cable to the SFP/SFP+ transceiver, and attach the
other end to the transceiver of the other devices. Note: SFP/SFP+ transceiver's TX port
should be connected to RX port of other device, and SFP/SFP+ transceiver's RX port
should be connected to TX port of other device.
Step 3: Check the fiber port status indicator, a light LED indicates that the link has been
established; otherwise the link is not ready and should be examined.
Caution!
Please verify the sign above the port to ensure using the other ports. Connecting to wrong
ports might damage the transceiver or the other ports. When connecting other devices
through a fiber cable to the switch, the output power of the fiber cable must not exceed the
maximum received power of the corresponding modules. Otherwise, it will damage the
fiber transceiver. Do not stare at the fiber bore when the switch is in operation. That may
hurt your eyes.
2.3.5 Power Supply Connection
DG-CS4616F uses 220V AC power. Please read the power input specification for the
detailed information.
Power supply connection procedure is described as below:
DG-CS4616F Installation Guide
Chapter 2-9