Digisol DG-CS4616F Installation Manual - Page 14

Browse online or download pdf Installation Manual for Switch Digisol DG-CS4616F. Digisol DG-CS4616F 17 pages. Giga layer 3 switch

Print Page

The connection procedure is listed below:

Find the console cable provided in the accessory kit. Attach the RJ45 end to console

port of the switch.

Connect the other side of the console cable to a character terminal (PC).

Power on the switch and the character terminal. Configure the switch through the

character terminal.

2.3.3 SFP/SFP+ Transceiver Installation

DG-CS4616F has multiple 10Gb interfaces and provides multiple 1000Mb SFP or 10Gb

SFP+ transceiver slots.

The procedure for installing the SFP/SFP+ transceiver is shown below:

Step 1: Put on a ESD wrist strap (or antistatic gloves)

Step 2: Insert the SFP/SFP+ transceiver to the guide rail inside the fiber interface line card.

Do not put the SFP/SFP+ transceiver up-side-down.

Step 3: Push the SFP/SFP+ transceiver along the guide rail gently until you feel the

transceiver snap into place at the bottom of the line card.

Note: the SFP/SFP+ transceiver is hot swappable.

Caution!

Do not stare directly at the 2 fiber bore in the SFP/SFP+ transceiver when the switch is in

operation, otherwise the laser may hurt your eyes.

Copper cables should be connected as below:

Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch

copper cable line card;

Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some other

device;

Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates

that the link has been established, otherwise the link is not ready and the cable should be

Fig 2- 3 Connecting Console to switch

Chapter 2-8

DG-CS4616F Installation Guide