Digisol DG-CS4616F Manual de instalação - Página 14

Procurar online ou descarregar pdf Manual de instalação para Interruptor Digisol DG-CS4616F. Digisol DG-CS4616F 17 páginas. Giga layer 3 switch

Digisol DG-CS4616F Manual de instalação
The connection procedure is listed below:
1.
Find the console cable provided in the accessory kit. Attach the RJ45 end to console
port of the switch.
2.
Connect the other side of the console cable to a character terminal (PC).
3.
Power on the switch and the character terminal. Configure the switch through the
character terminal.

2.3.3 SFP/SFP+ Transceiver Installation

DG-CS4616F has multiple 10Gb interfaces and provides multiple 1000Mb SFP or 10Gb
SFP+ transceiver slots.
The procedure for installing the SFP/SFP+ transceiver is shown below:
Step 1: Put on a ESD wrist strap (or antistatic gloves)
Step 2: Insert the SFP/SFP+ transceiver to the guide rail inside the fiber interface line card.
Do not put the SFP/SFP+ transceiver up-side-down.
Step 3: Push the SFP/SFP+ transceiver along the guide rail gently until you feel the
transceiver snap into place at the bottom of the line card.
Note: the SFP/SFP+ transceiver is hot swappable.
Caution!
Do not stare directly at the 2 fiber bore in the SFP/SFP+ transceiver when the switch is in
operation, otherwise the laser may hurt your eyes.

2.3.4 Copper Cable/Fiber Cable Connection

Copper cables should be connected as below:
Step 1: Insert one end of the Ethernet cable to the RJ-45 Ethernet port in the switch
copper cable line card;
Step 2: Insert the other end of the Ethernet cable to the RJ-45 Ethernet port of some other
device;
Step 3: Check all status indicators for the corresponding ports; a lighted LED indicates
that the link has been established, otherwise the link is not ready and the cable should be
Fig 2- 3 Connecting Console to switch
Chapter 2-8
DG-CS4616F Installation Guide