Digital Alert Systems R232-48VDC Instrukcja instalacji - Strona 6
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Router bezprzewodowy Digital Alert Systems R232-48VDC. Digital Alert Systems R232-48VDC 8 stron. Multiport rf router
Drukuj stronęOnce the wires are attached to the removable terminal strip it can be connected to
the mating connector in the Pocket Power Supply opening. There are two retention
screws on the terminal strip to secure the connector to the device.
The wires can then be routed along the power cable management tray and toward
the rear of the chassis. The completed connection and wire routing can be seen in
Figure 7 below.
Terminal strip mated to connector
Pocket Power Supply
Figure 7: R232-48VDC side view with DC power cabling installed and properly configured.
Once power connections are made the unit is ready for mounting.
3 Mounting
The R232 is designed to be mounted in a standard Electronic Industries Alliance
(EIA) 19" rack frame using the four mounting screw holes on the front of the chassis.
The 1.75" high chassis is a uniform one rack unit (RU) height.
Chassis Mounting
Holes
The 1.75" (4.45cm) high chassis fills a uniform one rack unit (RU) in height.
1.75 Inches
(4.45 cm)
R232 / R232-48VDC Installation Guide
TM
opening
Figure 8: Front panel mounting holes
Figure 9: R232 rear panel layouts
Power cable management tray
19 Inches (48.3 cm)
Power cabling routed to chassis rear
1U
Page 6 of 8