Siemens XQG90-WM14S7600W Instrukcja obsługi i instrukcja instalacji - Strona 32

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Siemens XQG90-WM14S7600W. Siemens XQG90-WM14S7600W 44 stron.

Faults and what to do about them

en
Faults and what to do about
them
Faults
Water is running out.
Water not flowing in.
Detergent not dispensed.
Washing machine door
cannot be opened.
Programme does not
start.
Detergent solution is not
drained.
Water not visible in the
drum.
Spin result not satisfac-
tory.
Washing wet/too damp.
Spin cycle activated sev-
eral times.
Residual water in the dis-
penser for care product.
Odour formation in the
washer dryer.
Loud noise formation,
vibrations and "wander-
ing" during spin cycle.
Display panel/indicator
lights do not function
while the appliance is run-
ning.
The programme duration
changes during the wash
cycle.
32
Cause/Remedy
Correctly attach/replace drainage hose.
Tighten screw-fitting on the supply hose.
Start/Reload not selected?
Tap not open?
Filter blocked? Clean the filter. ~ Page 29
Supply hose kinked or jammed?
Safety function active. Stop programme? Wait approx. 2 min.
- - - - (Rinse stop= without final spin) selected?
Can be opened with emergency lock release only. ~ Page 30
Childlock active? Deactivate. ~ Page 16
Start/Reload or 5 (Finished in) time selected?
Door closed?
- - - -(Rinse stop= without final spin) selected?
Clean the drain pump. ~ Page 28
Clean outlet pipe and/or drainage hose.
Not a fault – water below the visible area.
Distribute small and large items of washing in the drum.
æ (Less iron) selected?
Too low speed selected?
Not a fault – unbalanced load detection system adjusts imbalance.
Not a fault – effect of the care product not impaired.
If required, remove the insert. Clean detergent drawer and re-insert.
Run Drum clean 90 °C programme without washing.
Use standard detergent.
Appliance aligned?
Align the appliance. ~ Page 39
Appliance feet fixed?
Secure appliance feet. ~ Page 39
Transportation safety devices removed?
Remove transportation protection devices. ~ Page 37
Power failure? ~ Page 30
Fuse tripped? Switch on/replace fuse.
If the fault occurs repeatedly, call customer service. ~ Page 33
Not a fault – unbalanced load detection system adjusts imbalance.
Not a fault – foam detection function active. Additional rinse cycle.