Siemens XQG90-WM14S7600W Instrukcja obsługi i instrukcja instalacji - Strona 40

Przeglądaj online lub pobierz pdf Instrukcja obsługi i instrukcja instalacji dla Spryskiwacz Siemens XQG90-WM14S7600W. Siemens XQG90-WM14S7600W 44 stron.

Drukuj stronę
Installation and connection
en

Electrical connection

Electrical safety
:
Warning
Danger of death from electric shock!
Danger of death if live parts are
touched.
Never pull out the mains plug by
■
tugging the power cord.
Insert/pull out the mains plug with
■
dry hands only.
Never pull out the mains plug during
■
operation.
Connect the washing machine to an
■
alternating current via a correctly
installed earthed socket only.
The mains voltage and voltage
■
specifications on the washing
machine (appliance rating plate)
must match.
Connected load as well as required
■
fuse are indicated on the appliance
rating plate.
Ensure that:
the mains plug and socket match,
■
the cable cross-section is adequate,
■
earthing system has been installed
■
correctly.
A damaged power cord may
■
be replaced by an electrician only.
A replacement mains cable can be
obtained from customer service.
Do not use multiple plugs/couplings
■
or extension cables.
If a residual-current-operated circuit
■
breaker is used, use only a type
which features this symbol: z.
Only this symbol guarantees
compliance with the currently valid
regulations.
The mains plug must be accessible
■
at all times.
Before washing for the first
time
The washing machine was inspected
thoroughly before leaving the factory. To
40
remove any residual test water, run the
Drum clean programme the first time
without washing.
The washing machine must have
Note:
been installed and connected properly.
~ Page 36
Check the machine.
1.
Never switch on a damaged
Note:
machine. Inform your customer
service. ~ Page 33
Insert mains plug.
2.
Turn the tap on.
3.
Switch on the appliance.
4.
Close the washing machine door.
5.
Do not load any washing.
Select Drum clean 40°C
6.
programme.
Open the detergent drawer.
7.
Pour approx. 1 litre of water into
8.
dispenser II.
Add standard detergent to
9.
dispenser II according
to manufacturer's instructions for
light soiling.
To prevent frothing, use only
Note:
half the recommended amount
of detergent. Do not use any
standard or mild detergents.
Close the detergent drawer.
10.
Select Start/Reload.
11.
When the programme ends, switch
12.
off the appliance.
Your washing machine is now ready
for use.

Transportation

Remove covers and keep in a safe
1.
place.
If required, use a screwdriver.