Cisco 2525 Podręcznik konfiguracji - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik konfiguracji dla Router sieciowy Cisco 2525. Cisco 2525 23 stron. Troubleshooting guide
Również dla Cisco 2525: Podręcznik konfiguracji (23 strony), Przegląd (10 strony), Przygotowanie do instalacji (19 strony), Instrukcja rozwiązywania problemów (4 strony)

Configuring the Router

The results of the show running-config and show startup-config commands will be

different if you have made changes to the configuration but have not yet written them to

NVRAM.

To make your changes permanent, enter the copy running-config startup-config

command at the enable prompt:

The router is now configured and will boot with the configuration you entered.

Using AutoInstall

The AutoInstall process is designed to configure the router automatically after connection

to your WAN. In order for AutoInstall to work properly, a Transmission Control

Protocol/Internet Protocol (TCP/IP) host on your network must be preconfigured to provide

the required configuration files. The TCP/IP host may exist anywhere on the network as

long as the following two conditions are maintained:

The host must be on the remote side of the router's synchronous serial connection to the

WAN.

User Datagram Protocol (UDP) broadcasts to and from the router and the TCP/IP host

must be enabled.

This functionality is coordinated by your system administrator at the site where the TCP/IP

host is located. You should not attempt to use AutoInstall unless the required files have been

provided on the TCP/IP host. For Cisco IOS Release 11.0 and earlier releases, refer to the

publication Router Products Configuration Guide for additional information. For

Cisco IOS Release 11.1 and later releases, refer to the publication Configuration

Fundamentals Configuration Guide.

Note

switched 56-kbps DSU/CSU module operates on switched 56-kbps circuits only; therefore,

you cannot use it for AutoInstall.

4-4 Cisco 2524 and Cisco 2525 Router User Guide

Router# copy running-config startup-config

********

AutoInstall works on synchronous serial connections only. The 2-wire