Setting, Monitoring and Controlling from a Computer
Using the Mail Notification Function to Report
Problems
If settings for the mail notification function have been made, notification
messages can be sent to a computer with a preset e-mail address to alert the
operator at the computer, that a problem or warning has occured with a
projector, By using this function, the operator can be notified of problems
with projectors even at locations that are removed from the projector.
TIP
Up to a maximum of three notification destinations (addresses) can be
•
recorded, and notification messages can be sent to all three destinations at
once.
If a critical problem develops with a projector which causes it to suddenly
•
stop working, it may not be possible for the projector to send a message
notifying an operator of the problem.
If "Standby Mode" in the projector's "Advanced1" menu is set to "Network
•
ON", monitoring can be carried out even when the projector is in standby
mode (when the power is off).
Before using the Mail Notification Function, check the following point.
• Network settings have been made to enable the computer and
projector to connect via Access point mode or Wired LAN
connection mode. s "Connecting in Access Point Mode or Wired
LAN Connection Mode" in the EasyMP Setup Guide
f Mail Notification Settings
Mail notification settings are made on the mail screen of the Network
Screen Access point mode advanced settings screen, or the Wired LAN
connection advanced settings screen. s "Connecting in Access Point
Mode or Wired LAN Connection Mode" in the EasyMP Setup Guide
f If a Problem Notification is Sent by Mail
If an e-mail message with "EPSON Projector" in the subject line is sent to
the
IP addressesg
that have been set as mail notification destinations, the
message is a notification message saying that there is a problem with the
projector.
The following information will be contained in the body of the message.
Line 1 : The name of the projector where the problem has occurred
Line 2 : The IP address that has been set for the projector where the
problem has occurred
Line 3 : Details of the problem
EasyMP Operation Guide
37
Drukuj stronę