Cisco 7200 VXR Series Skrócona instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco 7200 VXR Series. Cisco 7200 VXR Series 48 stron. Preparing for installation
Również dla Cisco 7200 VXR Series: Arkusz danych (12 strony), Podręcznik (14 strony)
Drukuj stronę
Figure 3
Inserting an SFP Module into the NPE-G2 Gigabit Ethernet Port 0/1
L I N K
A C T V
E N
G IG A B IT
E T H E R
N E T 0 /
L IN K
A C T V
E N
R J 4 5
2
SFP port 0/1
1
Use the following procedure to install an SFP module in the NPE-G2:
Step 1
Attach an ESD-preventive wrist strap between you and an unpainted chassis surface.
Step 2
Locate the label on the SFP module and turn the SFP module so the label is on top and the alignment groove is down.
Note
The SFP module is keyed so that it cannot be inserted incorrectly.
Step 3
Insert the SFP module into SFP port 0/1, 0/2, or 0/3. The SFP module snaps into place when you have completely and
properly inserted it.
Step 4
Repeat Step 2 if you are inserting a second or third SFP module.
Note
Do not remove the plug from the SFP module optical bores until you are ready to install the network interface optical
fiber cable. Save the plug for future use.
Note
We strongly recommend cleaning all optical fiber connections before connecting optical cables to equipment. For
information about cleaning optical connectors, see the
Connections
document and the
See the Cisco 7200 VXR Installation and Configuration Guide for more information.
1
1
G IG A B IT
E T H E R
N E T 0 /
2
L IN K
A C T V
E N
R J 4 5
Compressed Air Cleaning Issues for Fiber-Optic Connections
SFP module
2
Inspection and Cleaning Procedures for Fiber-Optic
document.
9