Cisco AIR-LAP1310G Instrukcja montażu - Strona 15

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Bezprzewodowy punkt dostępowy Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40 stron. Cisco aironet 1300 series lightweight outdoor access point

Drukuj stronę

1. Mounting the Access Point

•

Tighten the bolts to secure the power injector to the access point. Torque bolts to 6 to 8 ft-lbs.

Connecting the Cables

This procedure explains how to connect the cables and how to ground the access point:

Connect the two short coax cables to the power injector and to the access point.

Step 1

Caution

Step 2

Find the building's grounding electrode system and then connect the access point ground lug to it using

6 AWG copper wire. Use a crimping tool to crimp the wire to the ground lug. For more information about

attaching the ground lug to the access point, see

to the Access Point" section on page

Warning

This equipment must be grounded. Never defeat the ground conductor or operate the equipment in the

absence of a suitably installed ground conductor. Contact the appropriate electrical inspection

authority or an electrician if you are uncertain that suitable grounding is available. Statement 1024

Note

Rooftop or Wall Mount

The mounting kit has a rooftop mounting bracket that is suitable for flat roofs, sloping roofs, and outdoor

walls. Mounting the access point on a rooftop or wall includes the following subtasks:

This warning applies to outdoor installations.

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

78-17634-01

Two short sub-mini RG-59 coax cables (12 in.)

To prevent damage to the access point or power injector, connect all coax cables from the

power injector to the access point and connect the power jack to the power injector before

applying power.

The grounding block and grounding wire are not required when mounting both the access point

and the antenna in a sheltered indoor environment.

Mounting the access point

Routing the cables

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Step 3

and

Step 4

28. See

Figure 11

for the ground lug location.

Mounting the Access Point

in the

"Attaching the Housing Bracket