Cisco AIR-LAP1310G Instrukcja montażu - Strona 33

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Bezprzewodowy punkt dostępowy Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40 stron. Cisco aironet 1300 series lightweight outdoor access point

Drukuj stronę

1. Mounting the Access Point

Connecting to the Console Serial Port

To access the access point CLI interface, you can connect a PC to the power injector console serial port

using a DB-9 to RJ-45 serial cable.

Note

On lightweight access points, you can only use the CLI interface when the access point is not associated

with a controller.

Follow these steps to open the CLI by connecting to the console serial port:

Connect a nine-pin, female DB-9 to RJ-45 serial cable to the RJ-45 serial port on the power injector and

Step 1

to the COM port on your PC.

Figure 14

Note

Set up a terminal emulator to communicate with the access point. Use the following settings for the

Step 2

terminal emulator connection: 9600 baud, 8 data bits, no parity, 1 stop bit, and no flow control.

When the terminal emulator is activated, press Enter. An Enter Network Password window appears.

Step 3

Enter your username in the User Name field. The default username is Cisco.

Step 4

Enter the access point password in the Password field and press Enter. The default password is Cisco.

Step 5

When the CLI activates, you can enter CLI commands.

78-17634-01

Figure 14

Console Serial Port Connector

Console serial port connector (RJ-45 connector)

The Cisco part number for the DB-9 to RJ-45 serial cable is AIR-CONCAB1200. Browse to

http://www.cisco.com/go/marketplace

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

Manually Configuring Controller Information Using the Lightweight Access Point CLI

shows the power injector's console serial port connector.

to order a serial cable.