Cisco AIR-LAP1310G Instrukcja montażu - Strona 34

Przeglądaj online lub pobierz pdf Instrukcja montażu dla Bezprzewodowy punkt dostępowy Cisco AIR-LAP1310G. Cisco AIR-LAP1310G 40 stron. Cisco aironet 1300 series lightweight outdoor access point

Drukuj stronę

1. Mounting the Access Point

Manually Configuring Controller Information Using the Lightweight Access Point CLI

Configuring Controller Information

Use these Exec mode CLI commands to manually configure controller information on a new access

point:

lwapp ap ip address <IP address> <subnet mask>

lwapp ip default-gateway IP-address

lwapp controller ip address IP-address

lwapp ap hostname name

Where name is the access point name on the controller.

The default Enable password is Cisco.

Note

Clearing Manually Entered Controller Information

When you need to move your access point to a different location in your network, you must clear the

manually entered controller information to allow your access point to associate with a different

controller.

This command requires the controller-configured Enable password to enter the CLI EXEC mode.

Note

You can use these EXEC mode CLI commands to clear or remove the manually entered controller

information:

clear lwapp ap ip address

clear lwapp ip default-gateway

clear lwapp controller ip address

clear lwapp ap hostname

Manually Resetting the Lightweight Access Point to Defaults

You can manually reset your lightweight access point to default settings using this EXEC mode CLI

command:

clear lwapp private-config

Note

This command requires the controller configured Enable password to enter the CLI EXEC mode.

Cisco Aironet 1300 Series Lightweight Outdoor Access Point Mounting Instructions

78-17634-01