Cisco Aironet 1240AG Series Skrócona instrukcja obsługi - Strona 34
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Bezprzewodowy punkt dostępowy Cisco Aironet 1240AG Series. Cisco Aironet 1240AG Series 49 stron. 802.11a/b/g access point
Również dla Cisco Aironet 1240AG Series: Arkusz danych (10 strony)
Drukuj stronę
Note
You can restore the access point to its factory defaults by unplugging
the power jack and plugging it back in while holding the Mode
button down until the Ethernet LED turns amber (approximately 2 to
3 seconds).
Enabling the Radio Interfaces
In Cisco IOS Release 12.3(7)JA, the access point radios are disabled by
default, and there is no default SSID. You must create an SSID and enable the
radios before the access point allows wireless associations from other
devices. These changes to the default configuration improve the security of
newly installed access points. Refer to the "Configuring Security Settings"
section on page 33 for instructions on configuring the SSID.
Follow these steps to enable the radio interfaces:
1. Browse to your access point.
2. When the Summary Status page appears, click Radio0-802.11G. The
2.4-GHz radio status page appears.
3. Choose the Settings tab at the top of the page. The radio settings page
appears.
4. Click Enable in the Enable Radio field.
34
OL-16714-01