Cisco Aironet 1240AG Series 빠른 시작 매뉴얼 - 페이지 34

{카테고리_이름} Cisco Aironet 1240AG Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Aironet 1240AG Series 49 페이지. 802.11a/b/g access point
Cisco Aironet 1240AG Series에 대해서도 마찬가지입니다: 데이터시트 (10 페이지)

페이지 인쇄

Note

You can restore the access point to its factory defaults by unplugging

the power jack and plugging it back in while holding the Mode

button down until the Ethernet LED turns amber (approximately 2 to

3 seconds).

Enabling the Radio Interfaces

In Cisco IOS Release 12.3(7)JA, the access point radios are disabled by

default, and there is no default SSID. You must create an SSID and enable the

radios before the access point allows wireless associations from other

devices. These changes to the default configuration improve the security of

newly installed access points. Refer to the "Configuring Security Settings"

section on page 33 for instructions on configuring the SSID.

Follow these steps to enable the radio interfaces:

1. Browse to your access point.

2. When the Summary Status page appears, click Radio0-802.11G. The

2.4-GHz radio status page appears.

3. Choose the Settings tab at the top of the page. The radio settings page

appears.

4. Click Enable in the Enable Radio field.

OL-16714-01