ACU-RITE 00639W Instrukcja obsługi - Strona 16

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Stacja pogodowa ACU-RITE 00639W. ACU-RITE 00639W 20 stron.
Również dla ACU-RITE 00639W: Instrukcja obsługi (14 strony)

Drukuj stronę

Problem

Inaccurate forecast

Inaccurate

temperature or

humidity

If your AcuRite product does not operate properly after trying

the troubleshooting steps, visit www.AcuRite.com or call

(877) 221-1252 for assistance.

Care & Maintenance

Display Unit Care

Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives. Keep away

from dust, dirt and moisture. Clean ventilation ports regularly with a gentle puff of air.

3-in-1 Sensor Care

Clean the Sensor

Clean with a soft damp cloth. Do not use caustic cleaners or abrasives.

Insect Prevention

Insects may cause obstructions and interrupt data by nesting in or on the 3-in-1 sensor.

To limit this problem, spray the outside of the sensor with a household insect repellent.

Consult the insect repellent instructions prior to use.

Snow & Freezing Weather

The 3-in-1 sensor will not be damaged by freezing conditions.

Clean the Wind Anemometer

Remove foreign matter from the outside of the sensor for free movement of the wind

vane and anemometer. If needed, use a small amount of spray lubricant, clear silicone

or graphite powder on the anemometer for improved movement.

• Weather Forecast icon predicts conditions for the next

12 to 24 hours, not current conditions.

• Has Learning Mode icon disappeared from the

display unit? Learning Mode must complete before

forecast and pressure will be accurate.

• Allow unit to run continuously for 33 days. Battery

removal or resetting the display unit will restart

Learning Mode. After 14 days, forecast should be

fairly accurate, however Learning Mode calibrates for

a total of 33 days.

• Make sure both the display unit and 3-in-1 sensor are

placed out of direct sunlight and away from any heat

sources or vents (see p.11).

• Make sure both units are positioned away from

moisture sources (see p.11).

• Make sure 3-in-1 sensor is mounted at least 5 ft off of

the ground.

Possible Solution