DigitaLinx DL-HD2-RX Instrukcja obsługi - Strona 9
Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Odbiornik DigitaLinx DL-HD2-RX. DigitaLinx DL-HD2-RX 13 stron.
Również dla DigitaLinx DL-HD2-RX: Podręcznik szybkiej instalacji (8 strony)
Drukuj stronęConnecting Audio
Audio Input (Transmitter only)
Connect an audio source to the transmitters audio input using a 3.5mm audio cable. The DL-1H1V1U-WP-W
supports a 3.5mm stereo unbalanced input
Audio Output
Connect an audio amplifier to the receivers audio output using a 3.5mm audio cable. The DL-HD2-RX
supports a 3.5mm stereo unbalanced output
Note: The DL-HD2-RX audio output only passes audio fed from the dedicated AUDIO IN port on the
DL-1H1V1U-WP-W transmitter wall plate, it does not pass embedded HDMI audio
Connecting Control
Connect the DL-HD2-RX receivers RS232 port to a displays serial connection for serial control.
Note: The DL-HD2-RX RS232 port can be configured to send stored serial commands from the
DL-1H1V1U-WP-W
For directions on RS232 configuration see complete list of control commands on pg13 RS232 / CEC
Control Configuration
RS232 Control Wiring
Connect the display devices RX RS232 signal to TX port of the DL-HD2-RX receiver. Then connect the displays TX RS232
signal to the RX port on the DL-HD2-RX receiver.
Apply Power
Plug the power supply into the power input port on the rear of DL-HD2-RX receiver. The receiver will power the
transmitter via HDBaseT. Twist the locking ring clockwise to prevent accidental disconnection of power.
DL-1H1V1U-WP-W Owners Manual
DL-HD2-RX
Display
RX
Device
Tx
RXD
Rx
TXD
GND
9