Cisco Catalyst IW6300 Series Instrukcja instalacji - Strona 23
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Bezprzewodowy punkt dostępowy Cisco Catalyst IW6300 Series. Cisco Catalyst IW6300 Series 28 stron. Product document of compliance
Również dla Cisco Catalyst IW6300 Series: Pierwsze kroki (20 strony)
Drukuj stronę
Installing the Access Point
Step 6
Carefully insert the RJ-45 cable connector into the Ethernet port opening on the access point, and connect to
the internal Ethernet connector.
Step 7
Ensure that the antennas are connected to the access point before you apply power to the access point.
Step 8
Route your Ethernet cable, and cut off any excess cable.
Step 9
Install an RJ-45 connector on the unterminated cable end, and insert it into the power injector.
Step 10
Turn on power to the power injector.
Connecting AC Power to IW-6300H-AC-x-K9
Note
When you install the conduit, be sure to comply with the local electrical codes for your area.
To route and connect the ground and AC power cabling to the IW-6300H-AC-x-K9 access point model, follow
these steps:
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022
Warning
When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Caution
Always install the ground wire before connecting all power leads.
Procedure
Step 1
Open the access point cover. See
Step 2
Ensure a 6 AWG (13.3 mm
, on page
Step 3
Route the AC power cable through the 1/2-NPT port.
Opening the Access Cover, on page 13
2
) ground wire is connected to the access point (see
19).
Connecting AC Power to IW-6300H-AC-x-K9
for instructions.
Grounding the Access Point
Installing the Access Point
23