Cisco Catalyst IW6300 Series Instrukcja instalacji - Strona 24
Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Bezprzewodowy punkt dostępowy Cisco Catalyst IW6300 Series. Cisco Catalyst IW6300 Series 28 stron. Product document of compliance
Również dla Cisco Catalyst IW6300 Series: Pierwsze kroki (20 strony)
Drukuj stronę
Connecting DC Power to IW-6300H-DCW-x-K9
Figure 16: Connecting Internal Ground and AC Power Connection for IW-6300H-AC-X-K9
1
2
Step 4
Use a wire stripper tool to remove the insulation from each wire. Remove only enough wire to provide a solid
connection in the terminal block. The hot wires should have no bare wire exposed after the connection is
made.
Step 5
Insert the ground wire into the internal ground.
Step 6
Insert each hot wire into the AC entry terminal block.
Step 7
Use a Phillips screwdriver to tighten the terminal block set screws to secure the wires in the terminal block.
Step 8
Verify that no bare wire is exposed. If wire is exposed, remove it from the terminal block, adjust the length,
and reinstall.
Step 9
Check your work.
Step 10
Close the access point cover. See
Connecting DC Power to IW-6300H-DCW-x-K9
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:10 A. Statement 1005
Warning
A readily accessible two-poled disconnect device must be incorporated in the fixed wiring. Statement 1022
Installing the Access Point
24
Customer-supplied harness
Customer-supplied cable (ATEX only)
Closing the Access Cover, on page 14
3
Terminal block
for details.
Installing the Access Point