Cisco CTS-SX10-K9 Podręcznik dla początkujących - Strona 14

Przeglądaj online lub pobierz pdf Podręcznik dla początkujących dla System konferencyjny Cisco CTS-SX10-K9. Cisco CTS-SX10-K9 25 stron. Telepresence sx10 quick set

Drukuj stronę

Cisco TelePresence SX10 Quick Set

SX10 Quick Set

SIP configuration

(When not set by a provisioning system)

To get online and ready to place and receive calls, your

system must be set up properly. Your system uses SIP

protocol for video calls.

NOTE:

Contact your system administrator, or service provider,

for information about the network settings.

You can find information about administering through Cisco

UCM in the

Administering TC endpoints on CUCM

The diagnostics on your system will indicate if there is a

problem with the SIP registering.

If you are changing a value setting,

you have to always click

save

to confirm the change.

Back to task overview

D15117.01 SX10 Getting Started Guide TC7.1, MAY 2014.

Contents

Introduction

SIP

If in doubt for any of the parameters below, contact your

system administrator or your service provider.

1. Go to the

Configuration

System

Configuration.

2. Open the

SIP

guide.

3. Under the

Profile 1

URI 1

input field, and optionally a display name in the

DisplayName

Select the preferred transport protocol from the

DefaultTransport

system first tries to connect using Tls, then TCP, and

finally UDP.

4. Select a proxy type in the

default type is Standard.

5. Go to the

Proxy 1

If you want the system to obtain the SIP proxy address

automatically, select

if you want to enter the address manually, select Manual.

If you select Manual, enter the proxy

corresponding input field.

6. If the SIP proxy requires authentication, you must enter

a login name and password to authenticate your system.

Go to the

Authentication 1

LoginName

fields.

7. Click the

Home

verify the SIP settings.

If you have successfully registered to a SIP server, the

Status

is shown as

If you wish to change the other SIP settings, check the

administrator guide for your product.

Configuration

tab, and select

page from the left sidebar.

heading, enter the SIP URI in the

input field.

drop down list. If you select Auto, the

Type

drop down list. The

subheading.

Auto

in the

Discovery

drop down list;

Address

in the

subheading and enter the

and

Password

in the corresponding input

tab to see the

System Information

and

Registered

in the SIP section.

Getting Started Guide

Appendices

Contact