DigiTech RP500 Skrócona instrukcja obsługi
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Pedał muzyczny DigiTech RP500. DigiTech RP500 2 stron. Installs cubase le 4, x-edit, and usb drivers
Również dla DigiTech RP500: Uzupełnienie (4 strony), Instrukcja instalacji oprogramowania (12 strony)
Drukuj stronę
WHAT'S IN THE BOX
RP500 Multi-Effects Switching System & USB Recording Interface
•
•
Power Supply
GET X-EDIT
To get the X-Edit software, visit
http://digitech.com/en-US/products/RP500#downloads.
REGISTER YOUR PRODUCT
To activate your warranty, please register at
http://digitech.com/en-US/support/warranty_registration.
GET THE OWNER'S MANUAL
Scan the QR code to get the owner's manual or visit
http://digitech.com/en-US/products/RP500#documentation.
1
MAKING CONNECTIONS / APPLYING POWER
A. Set your amp(s) to a clean tone, set the
tone controls for a flat EQ response
Live Application
(on most amps, this would be 0 or 5
on the tone controls), turn the volume
control(s) all the way down, then power
off the amp(s). If connecting to a mixer,
fully lower the corresponding channel
fader(s).
B. Make connections as shown in the
diagrams to the right, depending on
application type.
C. Connect the included power supply to
the POWER input jack and plug it into
an available AC outlet.
D. Set the RP500's MASTER LEVEL control
to 50.
E. Power on your amp(s). While playing,
slowly raise the amp volume control(s)
to the desired volume. If using a mixer,
adjust each channel's gain/trim and
fader controls for the desired volume.
2
A. To bypass effects, press the active BYPASS footswitch. The display will read "BYPASS".
Recording / Practice Application
B. To exit Bypass mode, press the BYPASS or any of the 1-5 footswitches.
C. To use the Tuner, press and hold the BYPASS footswitch for 2 seconds. The display will
briefly read "TUNER" then enter Tuner mode.
D. Play a note on the guitar. The note will be shown in the display and arrows in the display will
indicate if the note is sharp, flat, or in tune.
E. To exit Tuner mode, press the BYPASS or any of the 1-5 footswitches.
BYPASSING EFFECTS & USING THE TUNER
Press for Bypass,
In Tune
hold for Tuner
Flat
Sharp
E