DigiTech RP500 Hızlı Başlangıç Kılavuzu

Müzik Pedalı DigiTech RP500 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. DigiTech RP500 2 sayfaları. Installs cubase le 4, x-edit, and usb drivers
Ayrıca DigiTech RP500 için: Zeyilname (4 sayfalar), Yazılım Kurulum Kılavuzu (12 sayfalar)

Sayfayı Yazdır

WHAT'S IN THE BOX

RP500 Multi-Effects Switching System & USB Recording Interface

•

Power Supply

GET X-EDIT

To get the X-Edit software, visit

http://digitech.com/en-US/products/RP500#downloads.

To activate your warranty, please register at

http://digitech.com/en-US/support/warranty_registration.

GET THE OWNER'S MANUAL

Scan the QR code to get the owner's manual or visit

http://digitech.com/en-US/products/RP500#documentation.

MAKING CONNECTIONS / APPLYING POWER

A. Set your amp(s) to a clean tone, set the

tone controls for a flat EQ response

Live Application

(on most amps, this would be 0 or 5

on the tone controls), turn the volume

control(s) all the way down, then power

off the amp(s). If connecting to a mixer,

fully lower the corresponding channel

fader(s).

B. Make connections as shown in the

diagrams to the right, depending on

application type.

C. Connect the included power supply to

the POWER input jack and plug it into

an available AC outlet.

D. Set the RP500's MASTER LEVEL control

to 50.

E. Power on your amp(s). While playing,

slowly raise the amp volume control(s)

to the desired volume. If using a mixer,

adjust each channel's gain/trim and

fader controls for the desired volume.

A. To bypass effects, press the active BYPASS footswitch. The display will read "BYPASS".

Recording / Practice Application

B. To exit Bypass mode, press the BYPASS or any of the 1-5 footswitches.

C. To use the Tuner, press and hold the BYPASS footswitch for 2 seconds. The display will

briefly read "TUNER" then enter Tuner mode.

D. Play a note on the guitar. The note will be shown in the display and arrows in the display will

indicate if the note is sharp, flat, or in tune.

E. To exit Tuner mode, press the BYPASS or any of the 1-5 footswitches.

BYPASSING EFFECTS & USING THE TUNER

Press for Bypass,

In Tune

hold for Tuner

Flat

Sharp