Digitrax DS74 Podręcznik - Strona 6

Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca Digitrax DS74. Digitrax DS74 8 stron. Complete train control

Drukuj stronę

6.0 Advanced DT602 based DS74 configuration

To perform these advanced features, the DT602 will need to be user updated to

SubVersion 5.0 or higher, or a July 2021 or later IPL - see www.digitrax.com.

6.1 Detecting all DS74's and setting Base addresses:

updated DT602 plugged into LocoNet, press the; Menu>3>4 keys to enter the

Route Editor menu. If any DS74 is plugged into LocoNet, the DT602 will beep

after about one second and show "DS7x" routes at the D soft key position.

Press the D soft key to now enter the "Selecting DS7x device " screen as

shown below. This example DT602 screen shows four DS74 devices detect-

ed, their Base switch (SW) address, active switch address range# and unique

device serial numbers (SN or SerNo).

The lowest DS74 Base address detected and sorted is SW0001, with 4

outputs with SN 9122. This is displayed in GREEN to indicate that it does

NOT conflict with the second DS74 SN 3122 at Base address 5. This is true

because the next free address is SW1+4 or SW0005, that second DS74 SN

3122 is set at or above. You can use the LH encoder knob to scroll up and

down through the detected DS74 lines, with an underline showing the

selected DS74.

The third DS74 shown at Base SW9 has

8# outputs shown, so it is configured by

OPSW's to operate 8 on/off light outputs

instead of 4 T/C turnout controls.

The 4th DS74 at Base Sw10 overlaps the

third DS74, and so is displayed in RED

text, because SW9+8 would require the

4th DS74 SN9945 to have a base address

of at least Sw17 to avoid SW# overlaps.

Rotate the DT602 LH encoder knob to

underline the fourth DS74 line entry.

Press the numbers 1 then 7 then press

the A soft key "Chng Adr". The last DS74

will change to Base SW17 and now show

GREEN because there are now no SW

overlaps of any DS74's detected.

To identify the actual underlined fourth

physical DS74 on the layout; press the

F soft key "Ident" and just this DS74 will blink its ID/OPS/RTS leds for 3

seconds. Press "X" to exit any DT602 advanced mode.

This advanced DT602 capability allows you configure all DS74's in position

on a LocoNet layout, quickly and conveniently, even if all devices are initially

at factory-default Base SW1.

If you are using other types of Switch control decoders, you will have to note

their active SW addresses and manually ensure the DS74's are configured to

avoid these.

CsRt

Selecting DS7x device

Device:

DS74

DS7x device select: LH knob

Chng adr

— 6 —

Ident

Base+Out#

SerNo

Sw0001+04# 9122

Sw0005+04# 3122

Sw0009+08# 2500

Sw0010+04# 9945

www.digitrax.com

On an