Digitrax DS74 Podręcznik - Strona 4

Przeglądaj online lub pobierz pdf Podręcznik dla Jednostka sterująca Digitrax DS74. Digitrax DS74 8 stron. Complete train control

4.0 Other DS74 Options: OPSW changes

The DS74 configuration and behavior can be configured using 40 OPSW's. The

Factory default OPSW settings will configure most common requirements.

Press and hold the OPS button for about 3 seconds until the green ID and

RTS LEDs blink alternately. Release the OPS button. The DS74 is now

setup to configure OPSW 1 to 40 by sending the required SW# as Closed or

Thrown to setup an option.

Send a SW# in range 1-40 as Closed/Thrown matching the wanted settings

from OPSW Table 1 choices below.

When finished press and hold OPS button for 3 seconds to exit OPSW setup

mode. The DS74 will now restart with the new OPSW settings.

Factory default OPSW settings are shown in BOLD.

OPSW's not in this table are reserved and should be kept at Factory default T

settings for predictable operation.

OPSW40 =C will reset to Factory defaults on OPSW mode exit

Table 1: DS74 Opsw setting table

OPSW#

1,2,3,4

Action

T,T,T,T

Pulse Solenoid mode (4 out)

C,T,T,T

Slow motion mode (4 out)

C,T,C,T

Light mode (8 out)

C =Disable internal Routes

C= Ignore standard SW com-

mands ("Bushby bit")

C= 8 input lines trigger

Routes

C= DCC SW commands only.

Ignore LocoNet SW#'s

C= Do not echo Route SW's

to Loconet.

C= Use Capacitive Discharge

in Pulse solenoid mode

C= Factory Reset

— 4 —