Cisco PIX 501 Skrócona instrukcja obsługi - Strona 6

Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy Cisco PIX 501. Cisco PIX 501 20 stron. Data sheet
Również dla Cisco PIX 501: Skrócona instrukcja obsługi (20 strony), Arkusz danych (8 strony), Skrócona instrukcja obsługi (21 strony), Skrócona instrukcja obsługi (18 strony)

Drukuj stronę

Check the LEDs

CISCO PIX 501

F I R E W A L L

The LINK/ACT LED indicators on the front panel of the PIX Firewall are normally solid green when

a link is established and flashing green when the ports are active. Each inside Ethernet interface

(1 through 4) has two LEDs to indicate the operating speed and that the physical link is established.

Note

If all LEDs are operating as expected (see Table 1), this concludes the hardware installation. The

pages that follow include instructions on running PDM and additional optional procedures.

Table 1

PIX 501 LEDs

LED

State

POWER

Green

Off

LINK/ACT

Flashing

green

Green

Off

VPN TUNNEL Green

Off

100 MBPS

Green

Flashing

green

POWER

VPN TUNNEL

Description

The device is powered on.

The device is powered off.

Network activity, such as Internet access, is present.

The correct cable is in use, and the connected equipment has power.

No link is established.

Tip

If the LINK/ACT LED does not light up, you might be using the

wrong type of cable. Try replacing the yellow (straight-through)

Ethernet cable with the orange (crossover) Ethernet cable.

One or more IKE/IPSec VPN tunnels are active.

No VPN tunnels are active. The default configuration does not include

VPN. Thus, the VPN tunnel LED will only be enabled if VPN is added to

your configuration and a VPN tunnel is then established. Also, the LED

does not light up when PPTP/L2TP tunnels are established.

The interface is autonegotiated at 100-Mbps half or full duplex.

The interface is functioning at 10-Mbps half or full duplex.

LINK/ACT

100 MBPS