Cisco PIX 525 Podręcznik użytkownika - Strona 11
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt sieciowy Cisco PIX 525. Cisco PIX 525 30 stron. Security appliance
Również dla Cisco PIX 525: Arkusz danych (13 strony)
Drukuj stronę
Chapter 6
PIX 525
Replacing the Chassis Cover
To replace the chassis cover, perform the following steps:
Place the chassis bottom so that the front panel is facing you.
Step 1
Hold the chassis cover over the chassis bottom, and align each of the cover tabs with the chassis tabs at
Step 2
the top rear of the chassis. (See
Lower the front of the top cover to close the chassis, and ensure the following:
Step 3
•
•
•
When the chassis cover is properly assembled, no tabs are visible.
Secure the chassis cover with the four screws you previously removed.
Step 4
Reinstall all interface cables.
Step 5
Figure 6-10 Replacing the Chassis Cover
Step 6
Connect the power to the site power and power on the PIX 525. The internal power supply fan should go
on.
78-15170-02
The chassis cover tabs fit under the edge of the chassis rear panel so that they are not exposed.
The chassis tabs fit under the chassis cover so that they are not exposed.
The chassis cover side tabs on both sides fit inside the chassis side panels so that they are not
exposed.
Chassis cover
P O
W E
R
A C
T IV
E
Front panel
Figure
6-10.)
Chassis
tabs
C I S
C O
S E C
U R
I T Y
F I
R
P I X
E
W
5 2 5
A
L L
S E
R IE
S
Cisco PIX Security Appliance Hardware Installation Guide
Removing and Replacing the PIX 525 Chassis Cover
Chassis bottom
6-11