Cisco PIX 525 Podręcznik użytkownika - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Sprzęt sieciowy Cisco PIX 525. Cisco PIX 525 30 stron. Security appliance
Również dla Cisco PIX 525: Arkusz danych (13 strony)
Drukuj stronę
Chapter 6
PIX 525
Remove the component tray and all the screws holding the assembly in place. Refer to the
Step 3
and Replacing the PIX 525 Chassis Cover" section on page 6-9
Step 4
Determine the location of your system memory sockets (see
Use the markings on the motherboard to determine the socket numbers. Always install the first memory
Step 5
strip into the lowest socket number. Progressively add memory strips into higher numbered sockets.
Figure 6-11 System Memory Location on the PIX 525 Component Tray
Locate the wrist grounding strap in the accessory kit and connect one end to the unit or to the
Step 6
PIX security appliance chassis, and securely attach the other to your wrist so it contacts your bare skin.
With the wrist strap on your wrist, carefully grasp the memory strip from either end. Note that a DIMM
Step 7
strip has notches.
To install a DIMM strip:
Step 8
Remove the old memory strip by opening the two plastic wing connectors, and pulling the old strip
•
up. Discard the old strip.
When installing the memory strip in a PIX 525, install the new strip in Bank 0 as shown in
•
Figure 6-12
closing the wing connectors.
78-15170-02
and
Figure
6-13, by opening the two plastic wing connectors, inserting the strip, and
for more information.
Figure
6-11).
Cisco PIX Security Appliance Hardware Installation Guide
Installing a Memory Upgrade
"Removing
6-13