Cisco Prisma EtherLinX Instrukcja instalacji - Strona 14

Przeglądaj online lub pobierz pdf Instrukcja instalacji dla Sprzęt sieciowy Cisco Prisma EtherLinX. Cisco Prisma EtherLinX 38 stron.

Laser Safety,

Continued

Safe Operation For Software Controlling Optical Transmission Equipment

If this document discusses software, the software described is used to monitor

and/or control our and other vendors' electrical and optical equipment designed to

transmit video, voice, or data signals. Certain safety precautions should be observed

when operating equipment of this nature.

For equipment specific safety requirements, refer to the appropriate section of the

equipment documentation.

For safe operation of this software, refer to the following warnings.

WARNINGS:

• Ensure that all optical connections are complete or terminated before using

this equipment to remotely control a laser device. An optical or laser device

can pose a hazard to remotely located personnel when operated without their

knowledge.

• Allow only personnel trained in laser safety to operate this software.

Otherwise, injuries to personnel may occur.

• Restrict access of this software to authorized personnel only.

• Install this software in equipment that is located in a restricted access area.

Laser Safety Information

This laser based multi-mode transceiver is an IEC 60825-1 Amend. 2 Class 1 laser

product. It complies with FDA performance standards (21 CFR 1040.10 and 1040.11)

for laser products except for deviations pursuant to Laser Notice No. 50, dated July

26, 2001.

Note: All adjustments have been made at the factory prior to shipment of the

module. No maintenance or alteration of this device is required. No adjustments or

controls provided.

Class 1 Laser Product

Avoid possible exposure to hazardous levels of invisible laser radiation; do not view

laser aperture.

Continued on next page

4008226 Rev B