Cisco SG 100D-08 Skrócona instrukcja obsługi - Strona 6
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy Cisco SG 100D-08. Cisco SG 100D-08 13 stron. Unmanaged gigabit switch with qos
Również dla Cisco SG 100D-08: Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (13 strony)
Drukuj stronę
Insert a screw into each hole, leaving a gap between the surface
S
3
TEP
and the base of the screw head of at least 0. 1 inches (3 mm).
Place the unmanaged switch wall-mount slots over the screws and
S
4
TEP
slide the unmanaged switch down until the screws fit snugly into
the wall-mount slots.
Connect the unmanaged switch to the other devices, as described
S
5
TEP
in the
"Connecting the Equipment"
Flat Surface Installation
To deploy the device on a desktop or other flat surface:
Place the unmanaged switch on a desktop near an AC power
S
1
TEP
source.
Connect the unmanaged switch to the other devices, as described
S
2
TEP
in the
"Connecting the Equipment"
Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide
section.
section.
6