Cisco SG 100D-08 Skrócona instrukcja obsługi - Strona 7
Przeglądaj online lub pobierz pdf Skrócona instrukcja obsługi dla Sprzęt sieciowy Cisco SG 100D-08. Cisco SG 100D-08 13 stron. Unmanaged gigabit switch with qos
Również dla Cisco SG 100D-08: Skrócona instrukcja obsługi (8 strony), Skrócona instrukcja obsługi (13 strony)
Drukuj stronę
4
Connecting the Equipment
This section describes the process for connecting the device to the
network.
Power down all of the devices you want to connect to the switch.
S
1
TEP
Connect the Ethernet cable to the Ethernet port of a PC, printer,
S
2
TEP
network storage, or other network device.
We recommend using Cat5e or better cable. Also, do not
N
OTE
exceed the maximum cabling distance of 328 feet (100 meters)
per segment.
Connect the other end of the network Ethernet cable to one of the
S
3
TEP
numbered unmanaged switch Ethernet ports.
Repeat
S
4
TEP
the unmanaged switch.
Make sure you use the power adapter included with the
C
AUTION
switch. Using a different power adapter might damage the
switch.
Connect the power adapter to the power port on the back panel of
S
5
TEP
the unmanaged switch.
Power up the devices connected to the switch. The LED of each
S
6
TEP
active port on the switch lights.
To prioritize voice or video traffic by using the QoS feature on the
N
OTE
Cisco SG 100D-08, set flow control to off in the configurations
of the connected devices. Otherwise, flow control might send a
pause frame to the switch, blocking the high-priority QoS
packets queued on the port. On some devices, such as some IP
phones and IP cameras, flow control might not be configurable.
7
Step 2
and
Step 3
Cisco SG100D-08 Unmanaged Gigabit Switch Quick Start Guide
for each device you want to connect to