Cisco 2600 Series Informacje o wersji - Strona 21

Przeglądaj online lub pobierz pdf Informacje o wersji dla Serwer Cisco 2600 Series. Cisco 2600 Series 32 stron. Configuring adsl wic to support pppoe clients
Również dla Cisco 2600 Series: Instrukcja instalacji (12 strony), Konfiguracja (15 strony), Nota aplikacyjna (41 strony), Arkusz danych (6 strony), Dodatek (15 strony), Instrukcja instalacji (22 strony), Przegląd (13 strony), Skrócona instrukcja obsługi (2 strony), Podręcznik (5 strony)

Cisco 2600 Series Informacje o wersji
When asked whether the system configuration has been modified, enter yes:
Step 7
# System configuration has been modified. Save? yes
If the password prompt appears, enter the password.
Step 8
Password: <password>
Step 9
At the router prompt, enter enable and then the password:
Router(boot)> enable
Password: <password>
If you are not upgrading a CiscoPro CPA1600 router, skip to Step 19.
Step 10
At the router prompt, enter the following command to copy the router upgrade utility
Step 11
from the PC CD-ROM drive to the router:
Router(boot)# copy tftp flash
If you are using rcp, enter copy rcp flash instead.
Note
When prompted, enter the IP address of your PC, as in the following example:
Step 12
Address or name of remote host [255.255.255.255]? 172.11.1.1
This is the IP address of your local PC, not the router. (Note that you can obtain your PC
IP address from the DOS prompt in the windows directory by entering winipcfg, as
follows:
C:\WINDOWS> winipcfg
When prompted, enter the filename of the image to be copied to the router as in the
Step 13
following example:
Source file name? cpa1600-upgrade-l.112-3.P
The upgrade image file on the Feature Pack CD has a long filename
Note
(cpa1600-upgrade-l.112-3.P); note that DOS displays it in 8.3 format as cpa1600~1.P.
The upgrade utility is a special file, not a Cisco IOS run-time image.
Step 14
In response to the following prompt, enter the destination filename, and press Enter.
Destination file name [cpa1600-upgrade-l.112-3.P]?
cpa1600-upgrade-l.112-3.P
(This is the name of the image file on the router, not the full pathname of the image on
the PC CD-ROM.)
During the transfer process, messages indicate that the software has accessed the file you
have specified and is loading it.
If the file is not found, check the following:
The filename is correct.
The TFTP server is enabled.
The correct root directory is selected.
There is IP connectivity between the router and TFTP server.
Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers
.)
Alternatives to RSL
21