Cisco 2600 Series Примітки до випуску - Сторінка 21

Переглянути онлайн або завантажити pdf Примітки до випуску для Сервер Cisco 2600 Series. Cisco 2600 Series 32 сторінки. Configuring adsl wic to support pppoe clients
Також для Cisco 2600 Series: Посібник з монтажу (12 сторінок), Конфігурація (15 сторінок), Примітка до заявки (41 сторінок), Технічний паспорт (6 сторінок), Додаток (15 сторінок), Посібник з монтажу (22 сторінок), Огляд (13 сторінок), Посібник із швидкого старту (2 сторінок), Посібник (5 сторінок)

Друкувати сторінку

When asked whether the system conﬁguration has been modiﬁed, enter yes:

Step 7

# System configuration has been modified. Save? yes

If the password prompt appears, enter the password.

Step 8

Password: <password>

Step 9

At the router prompt, enter enable and then the password:

Router(boot)> enable

Password: <password>

If you are not upgrading a CiscoPro CPA1600 router, skip to Step 19.

Step 10

At the router prompt, enter the following command to copy the router upgrade utility

Step 11

from the PC CD-ROM drive to the router:

Router(boot)# copy tftp flash

If you are using rcp, enter copy rcp ﬂash instead.

Note

When prompted, enter the IP address of your PC, as in the following example:

Step 12

Address or name of remote host [255.255.255.255]? 172.11.1.1

This is the IP address of your local PC, not the router. (Note that you can obtain your PC

IP address from the DOS prompt in the windows directory by entering winipcfg, as

follows:

C:\WINDOWS> winipcfg

When prompted, enter the ﬁlename of the image to be copied to the router as in the

Step 13

following example:

Source file name? cpa1600-upgrade-l.112-3.P

The upgrade image ﬁle on the Feature Pack CD has a long ﬁlename

Note

(cpa1600-upgrade-l.112-3.P); note that DOS displays it in 8.3 format as cpa1600~1.P.

The upgrade utility is a special ﬁle, not a Cisco IOS run-time image.

Step 14

In response to the following prompt, enter the destination ﬁlename, and press Enter.

Destination file name [cpa1600-upgrade-l.112-3.P]?

cpa1600-upgrade-l.112-3.P

(This is the name of the image ﬁle on the router, not the full pathname of the image on

the PC CD-ROM.)

During the transfer process, messages indicate that the software has accessed the ﬁle you

have speciﬁed and is loading it.

If the ﬁle is not found, check the following:

•

The ﬁlename is correct.

•

The TFTP server is enabled.

•

The correct root directory is selected.

•

There is IP connectivity between the router and TFTP server.

Release Notes for Cisco IOS Release 12.0(7)XK1 Feature Packs for Cisco 2600 Series Routers

Alternatives to RSL