Cisco AS5800 Podręcznik - Strona 13
Przeglądaj online lub pobierz pdf Podręcznik dla Serwer Cisco AS5800. Cisco AS5800 16 stron. Access server channelized t1/e1 trunk cards
Również dla Cisco AS5800: Podręcznik (22 strony)
Drukuj stronę
Chapter 3
Channelized T3 Trunk Card
Table 3-3
Command
Step 1
AS5800> enable
Password: password
AS5800#
Step 2
AS5800# configure terminal
Enter configuration commands, one per
line. End with CNTL/Z.
AS5800(config)#
Step 3
AS5800(config)# interface loopback 0
%LINEPROTO-5-UPDOWN: Line protocol on
Interface Loopback0, changed state to
up
Step 4
AS5800(config-if)# loopback local
Step 5
AS5800(config-if)# no shutdown
Step 6
AS5800(config)# controller t3
shelf/slot /0
Step 7
AS5800(config-controller)# t3
description ascii-string
Step 8
AS5800(config-controller)# cablelength
200
Step 9
AS5800(config-controller)# framing
c-bit
Step 10
AS5800(config-controller)# t1 ds1
controller
Step 11
AS5800(config)# controller t1
shelf/slot/port:t1-num
Step 12
AS5800(config-controller)# clock source
line
78-7097-03
T3 Configuration Commands
Description
Enter the enable command.
Enter your password.
You are in privileged EXEC mode when the prompt
changes to
.
AS5800#
Enter global configuration mode by entering the
configure terminal command. The example uses the
terminal configuration option.
You are in global configuration mode when the prompt
changes to
AS5800(config)#.
Enter interface loopback 0 to create interface
loopback 0, which is the logical IP subnet containing
all dial-in user addresses.
You are in interface mode when the prompt changes to
AS5800(config-if)#.
Set the normal data path back to its source (either local
or network).
Enable the interface using the no shutdown
1
command.
Enter controller configuration mode to configure your
T3 controller port. The only legal port value is 0.
Enter an optional text description for the T3 controller.
Enter the controller cablelength value, from 0 to 450
(feet).
Enter the type of T3 framing used. C-bit specifies C-bit
parity framing. M23 (default) specifies M23
multiplexer framing.
Create a logical T1 controller from each of the
specified T3 line time slots. The entry ds1 is a time slot
within the T3 line with a value from 1 to 28.
Enter controller configuration mode to configure your
T3 controller port. T1-num is a T1 timeslot within the
T3 line with a value from 1 to 28.
Configure the clock source as an internal clock
(internal) or a recovered clock (line).
Cisco AS5800 Universal Access Server Dial Shelf Card Guide
Configuring the CT3 Trunk Card
3-13